[Jewelry making - Article 00339] - Re: [Orchid] 95-5 Plaladium as casting Alloy

[Jim Zimmerman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi James,

    Thanks for the reply. 

    I use the PUK2 with argon, not the same as a laser I know. But, going
    through what the company said about post. Something's are still
    better solder the traditional way. Solder creates a fillet and is
    stronger. I'm still learning the PUK2 stuff. There are things it does
    quite well. I can tell you that it doesn't like thin cross section,
    even on lowest setting. Sorta like magic, they just disappear. 

Jim

 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________