[Jewelry making - Article 00952] - Re: [Orchid] Experience With Puk 2

[Colin Waylett]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    James, one of the reasons for buying a puk was for repairing billets
    and sheet during rolling rather than use solder which could lead to
    problems when soldering the Mokume gane into pieces of jewellery. Am
    I right in my thinking? 

    Mokume Gane apart, I think the Puk opens a new field for jewellery
    design being able to use stones,pearls,Titanium etc in other ways
    than up till now. So far I have only seen a Puk demonstated at a
    trade fair by a salesman (not a jeweller) my tool dealer as yet has
    not sold one so I have been unable to get a jewellers opinion (until
    now). 

Regards
Colin Waylett
Spain

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________