[Jewelry making - Article 00902] - [Orchid] Removing drill bits from Pearls

[Sharon]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I'm trying to drill completely through large (12-15mm) gray pearls.
    I've broken off my drill bit in two of the pearls. One is broken
    deep inside the pearl, almost drilled all the way through, the other
    is broken off at the top of the pearl and I can feel a little of the
    bit sticking out of the top. Help, does anyone have a clue as to how
    I can get these bits out of the pearls? 

Thanks! SD 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________