[Jewelry making - Article 00583] - [Orchid] Running true on tapered spindles

[Peter Grieve]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Does anyone know of a trick to threading felt buffs on tapered
    spindles so that they run true? I try a half turn at a time, and
    check in between, but somehow they always come out way off. 

    Forgive me if this is a repost, I would have sworn I posted it
    before, but cannot find any sign of it on the site. Deja vue all over
    again... 

PG

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________