[Jewelry making - Article 00498] - Re: [Orchid] Glass bezel

[Kim Griffith]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Find a good glass studio/blower with cold finishing equipment.
    Preferably one with a glass lathe or a glass cutter on staff. They
    will have the facilities to cut your bezel and to high polish the
    bezelled edge of the bezel, so to speak, through a series hand
    finishing operations using various grades of silicon carbide grit and
    finishing on cork wheels with pumice and cerium oxide.... the only
    problem may be the size simply in terms of holding something very
    small against a polishing wheel! 

My two-penneth!
:-) Kimmyg

kim AT kimmyg.com.au
http://www.kimmyg.com.au

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________