[Jewelry making - Article 00268] - Re: [Orchid] New Titanium Alloy

[BBoone5619]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    In titanium ring manufacture we walk the line between hardness and
    being able to have it cut off in an emergency. The typical aerospace
    alloys we use are around Rockwell 35 and can still be cut by hacksaw
    or ring cutters. What is the hardness of the alloys you are working
    with, and do you produce it in bar form? 

Bruce Boone
Boone Titanium Rings
www.boonerings.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________