[Jewelry making - Article 00139] - Re: [Orchid] Smith Little Torch with Victor outfit

[Terry Ogden]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi V

    The answer is yes, that is how I do mine. I got a couple of Y's at
    the local welding store with shutoffs. I turn my Victor torch off
    when I am using the Smith and my line pressure is much lower with the
    Smith. I am running 10 psi on Oxy and 5 psi on Acet. Or maybe it was
    5 and 5. Experiment... 

    HOWEVER.... If you have used your Smith with anything else,
    specifically compressed air from an air compressor I would not do it.
    Even the smallest residue of oil in the oxygen line could be
    catastrophic. 

Terry

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________