[Jewelry making - Article 00335] - Re: [Orchid] Soldering around CZ

[I Fasko]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    ... So, while I was trying to solder the jumprings next to my CZ's,
    I switched to a smaller torch tip - a prestolite #2. I wasn't able to
    use it cause it kept blowing itself out, no matter how low I turned
    the gas wheel. I also tried turning the black knob affixed to the
    gauge, but I have to admit, I don't know what I am doing here.... 

    Any hints on this? Now that I tried to use it, I remember that I've
    *never* been able to get this tip (or the one below it) to stay lit. 

thanks again -
Ivy

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________