[Jewelry making - Article 00176] - Re: [Orchid] Soldering around CZ

[Ivy]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thanks to all who replied to my question on this topic! 

    I had 4 to do, and two were not yet set, but had other attachments,
    so I tried those first - shielded the parts I thought might get
    damaged with a piece of tin, as it was too akward to get the piece
    into water, and I didnt have any cool jewl, etc to coat it with, That
    worked. I havent gotten up the nerve to try the pieces that had
    stones set yet - I think I'll wait till I get some stone shielding
    goo... 

Thanks again
Ivy

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________