[Jewelry making - Article 00491] - Re: [Orchid] Claw Setting Jig

[daniel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Noel, that was me. Daniel. I think you wrote me Via MidWstMetalSmith
    as well about local possibilities. 

    Its pretty easy to use. Depending on what size you need pick the
    outside collar. cut your wire, over length wanted is best. Its easier
    to take away than to add. Put the wires in the slots of the inside
    mandrel, slide the collar over and solder the ends. You have to
    finish the prongs and stuff by hand. If you are using real heavy wire
    you can use a smaller slotted mandrel and a larger cone. It basically
    just holds everything in place while you can solder it.


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________