[Jewelry making - Article 00158] - Re: [Orchid] Disc cutter

[Noah Ark]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    You might making the entire unit out of piece but divide it into two
    but connected with dove tail slides on each side so it will stay
    aligned but still be able to be sized down to whatever weight of
    metal you are cutting. Also, you will need some sort of exact locking
    method which could be as simple as several set screws

Peace,
Richard

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________