[Jewelry making - Article 00949] - Re: [Orchid] Rivet Clamp?

[Silververkstan d&b]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I looked at your site to be sure I understood the question correctly.
    On the assumption that both parts are similar in size and form, my
    solution would be a sturdy board (wood or something similar) and a
    couple of small blocks. Align three blocks so that the workpiece
    rests steadily on three points. Correcly done you can now exchange
    workpiece and find the exact position. Using a small drillstand it
    should now be possible to drill the pieces one at the time and still
    get the holes in the same position. 

    Hope this tip isn't too muddled to understand. 

kindly
michaela

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________