[Jewelry making - Article 00475] - [Orchid] [Beginners' Corner] Jewelry manufacturing procedures

[Deirdre Brown]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have jewelry design ideas, but do know the steps needed to get the
    pieces created. I have no jewelry manufacturing experience. I am
    considering purchasing a CAD program? Which one would be best for a
    person with advanced graphic design experience, but no jewelry
    design experience? In other words I am experienced in using graphic
    design software, but not 3d software. And then what do I do with the
    drawing? How do I get the pieces made? I apologize in advance if the
    answer to these questions are obvious. I am just not clear on how to
    get from point A to point C.

-Thank You.

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________