[Jewelry making - Article 00950] - Re: [Orchid] I'm buying a kiln for enameling

[Elaine Luther]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Remember that if you buy a kiln with a window, or even a peephole,
    there will be some heat loss through that. 

    I support your interest in the Paragon kiln. Admittedly, I've only
    used Paragon, but they make good kilns that hold up and you can get
    replacement parts. 

    I got my Paragon SC-2 in 1999 and it gets _very_ hard use. I travel
    with it to all my classes, and I don't box it up or baby it when I
    travel. And it gets run a lot in workshops at fast ramp speeds. 

    It's holding up really well. I've burned off some paint...but
    everything else works perfectly. 

Elaine

Elaine Luther
Metalsmith, Certified PMC Instructor
http://www.CreativeTextureTools.com (TM)
Hard to Find Tools for Metal Clay

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________