[Jewelry making - Article 00837] - Re: [Orchid] Flex shaft Quick Release Handpiece

[Milt Fischbein - Jewellery Artist]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Dave

>    I've got a #18 handpiece as well & have noticed the same thing,
>    occasionally burs are difficult to remove.
>
>    I've found that pressing the release lever down all the way & then
>    pushing the bur in a little farther usually makes it easier to
>    remove.

    Thanks for the tip on removing the bit from the #18 hand piece. I no
    longer have my #18, but did like it while I had it. If you were going
    to buy a new one, would you buy the #18 again, or would you buy
    something else? 

Milt Fischbein

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________