[Jewelry making - Article 00148] - Re: [Orchid] Shellac Removal

[Thackeray Taylor]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>         thermoplastic is the answer. Thermoplastics are good for
>     engraving type setting, like bright cut and pave, but you have to
>     be careful that the plastic doesn't ooze up through the holes
>     because it's difficult to get it out of the way of the stone. 

Hello David,

    When applicable a good tip to prevent any thermoplastic from getting
     into areas it can't be removed is to use something to fill the void
    that  can be dissolved by water or even a solvent. I've heard some
    people use  cake frosting, but just about anything that will
    dissolve can be used. 

Sincerely,
Thackeray Taylor
Rio Grande Technical Support

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________