[Jewelry making - Article 00020] - Re: [Orchid] Suggestions for stock to take to class

[M'lou Brubaker]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I would take 20 to 24 gauge, with maybe some 18 for a few stones. It
    depends on whether you plan to file the backing flush with the bezel,
    or leave it sticking out as a decorative edge. You wouldn't want such
    an edge to be too thin...looks cheap. Keep in mind that you can also
    saw out most of the backing on some designs, after you solder the
    bezel on. This leaves you with another piece to use as the backing
    for a smaller stone. It all depends on what your design for the
    jewelry piece will be. Avoid going too light with larger stones, at
    first, as you might tend to get warping if you overheat. As a
    beginner (again) you may burn up a few. Do not despair! Keep
    practicing, and you will soon get very good at it. It's not that
    hard to do...one just has to learn how, and Practice! Have a great
    time. 

    P.S. Have you asked the school what gauge they sell to students for
    this class? 

M'lou Brubaker, Jeweler
Goodland, MN
www.craftswomen.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________