[Jewelry making - Article 00868] - Re: [Orchid] Good results polishing by hand

[Chris Penner]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi,

    I often polish by hand as sometimes it is the best way to get into
    small spaces or simply get a good flat surface without putting in
    more scratches than you take out. 

    To start, I recommend taking the piece down to at least a 1,200 grit
    paper, make sure you sand in more than one direction as that allows
    you to see if there are any scratches left, and using a sanding stick
    (the paper wrapped around a bit of wood) will speed the process. I
    then go from a medium greasy (a polishing compound, I think it
    equates to about a 6000 grit paper) to High Bright (also called White
    Diamond, a fast cutting compound advertised for polishing steel, its
    faster and gives a better finish than tripoli) and finish with rouge.
     As a backing I tend to use a rag, thread or piece of leather,
    depending on the job, and will support this with a bit of wood if
    required. Some turps or paint thinner (NOT nitrocellulose!), can be
    used as well to help get the polishing compound onto the backing, but
    this is not always necessary. It also helps to clean the piece between
    changes in compound, and obviously change the backing. 

    Then there is elbow grease. Polishing is always a massive effort, and
    by hand you really feel it. Very satisfying though. 

    Also a handy tip on cutting things out  draw it on paper first and
    then glue it to the metal. If you rough the surface of the metal up
    with fine steel wool and use wood glue (PVA) then it will hold well,
    it is also handy as it removes the problem of the reflection making
    it difficult to follow the pattern. Purists recommend using rice
    paper, but in reality standard stuff works just fine. Which means
    that you can design on computer and then use the print out as a
    template, opening the whole of the internet to you for inspiration
    clip art is particularly good. And sit low the work piece should be
    in line with your chest, it makes controlling the saw easier and is
    better for your back. 

Good luck.

Chris Penner
Chris.at.collarsandcuffs.co.uk

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________