[Jewelry making - Article 00485] - Re: [Orchid] Disc Cutter Use

[Kim Griffith]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have had a little play with 1.2mm well annealed sterling and as
    you say, had no problems except when I didn't hit the hammer hard
    enough and it bounced, perhaps the softer approach might work better
    with the finer punches which are obviously more fragile as the set
    arrived with a spare of each of the smallest sizes......of course, I
    am no expert, just a beginner right at the very beginning! I have
    been most thankful for all posts, there are some great
    sugggestions..... thanks for your practicality though Richard! :-) Kimmyg

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________