[Jewelry making - Article 00452] - Re: [Orchid] Resurfacing rolling mill

[Jerry]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Resurfacing rolling mills is easy to do, the rollers may be as hard
    as all get out from usage. I am a machinist, and have made new
    rollers for myself. The cost factors can be setup time in the shop,
    which varies greatly then the actual work time, my shop is $75 an
    hour, heat treating is $50 per run through the oven. If I may
    suggest that you ask a machine shop make you some new rollers that
    are made out of S7 steel and have them heat treated. They will last
    forever. 

Jerry

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________