[Jewelry making - Article 00155] - Re: [Orchid] Recommendations on a scroll saw?

[Dianne deBeixedon]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hi, At the SNAG conference in Cleveland, Lee Marshall demonstrated a
    type of "scroll" saw that he designed. It held standard jewelers
    blades. I did try it out at the conference and it cut very smoothly
    and was easy to use. I did not brake a blade even making sharp
    turns.     Dianne deBeixedon 

    You might contact Lee Marshall and check out the saw - his contact
    is: 

	Bonny Doon Engineering, Inc.
	250 Tassett Ct.
	Bonny Doon, CA 95060

	Information: 831-423-1023
	Sales: 800-995-9962
	Fax: 831-423-1605

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________