[Jewelry making - Article 00084] - Re: [Orchid] Disc Cutter Use

[John Burgess]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

G'day;

    I have made a series of shape cutters for sterling sheet. But having
    put the sheet in place, between the positive and negative dies, I'd
    never give it a bash! My method is to put it in a bench vice, tighten
    to grip it, then tighten fully with a swift turn of the handle, and
    that gives a nice clean cut without spoiling the dies. 

Cheers for now,
John Burgess; johnb AT ts.co.nz of Mapua, Nelson NZ

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________