[Jewelry making - Article 00069] - Re: [Orchid] Recommendations on a scroll saw?

[Donna Shimazu]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Sheridan,

    You might want to contact Lee Marshall of Bonny Doon.  He had a
    prototype machine at Rio Grande's Catalog in Motion in Tucson this
    past February.  I don't know what it will cost, but it was very
    responsive. It had easy to change blades. The table could be angled
    to cut pancake/RT dies. The work piece could be maneuvered by
    guiding with your two hands. The best way to describe cutting with
    the saw was like guiding fabric on a sewing machine. It had a foot
    pedal. 

    Cynthia Eid might be able to tell you more about Lee's saw as she
    was working the show. I think Brian Marshall may have posted a
    review on the saw after the Tucson Show. 

Donna Shimazu 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________