[Jewelry making - Article 01267] - [Orchid] Paste solder tips

[Alysia Murray]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi,

    I've used paste solder for soldering a few jump rings - my first
    experience with both. :) ... I did, however, have a problem with the
    tips - For the life of me, I could not get the tips to work - I
    could not push it through no matter how hard I squeezed the syringe.
    After trying 3 different tips, I finally gave up, using a toothpick
    to apply it, which was somewhat of a PIA. I wondered if there's
    something else about those tips I'm supposed to know? Do you need to
    pierce it somewhere or ??? I've feel sorta silly asking this
    question, but I feel sillier that everyone else is using their paste
    solder and I'm not, just b/c I can't figure the tips out, so ... any
    advice would be appreciated! 

~Alysia
Hoping everyone is enjoying their Memorial Day holiday
www.alysiamurray.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________