[Jewelry making - Article 00670] - Re: [Orchid] Most productive way to produce shot

[Zen Sojourner]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>         There's a tool called a tubing cutter jig (e.g., Rio Grande
>     #113-839) which can eliminate the measuring part so all you have
>     to do is cut -- and that's a lot easier than making rings and
>     sawing (in my opinion, of course). 

    I've seen the tool. I just have no need for it. On those few
    occasions when I need straight SHORT pieces of wire I just use the
    hole-in-a-pvc-tube method. And since I already use a bazillion jump
    rings, I've already got them, they're always the same size, etc.
    Just easier for me. 

Sojourner

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________