[Jewelry making - Article 00630] - Re: [Orchid] Cutting and Shaping Amber

[gnmhllw]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I've been trying to catch all the replies here in hopes of figuring
    out where I'm going wrong try to polish amber once cut and shaped.
    I've had a piece from the beginning that I'd drilled and was giving
    that smirk of success when the end popped off . So I reconfigured the
    design to cap the section I'd repaired but for some reason have not
    been able to get a polish back on. It's been riding the vibratory
    tumbler while I've gone on to bigger things but I hate leaving
    something undone. 

Lisa in NY where the lilacs are blooming.

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________