[Jewelry making - Article 00520] - Re: [Orchid] Bounceless mallet

[NLS]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thanks for the suggestions everyone. 

    I was having trouble finding deadblow hammers or bounceless mallets
    smaller than 2 lbs at the Home Depot/Lowe's/Ace store here. I've
    looked at the book (Professional Goldsmithing)  again and the Otto
    Frei polypropylene mallet looks just like the mallet shown in the
    photographs- But I'm going to be cheap and try the Stanley brand
    slimline from Enco, dimensions seem to be the same and since I own a
    couple of other Stanley hammers and they fit my hand I'm hoping this
    one will also fit. 

Nora
noraligia_AT_earthlink.net


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________