[Jewelry making - Article 00431] - Re: [Orchid] Bouncless mallets

[David Giulietti]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have bought two very nice deadblow mallets from Enco. 

    http://www.use-enco.com/ 

    The mallets are very inexpensive and come in a number of sizes.These
    are one piece black mallets covered in rubber or some type of
    plastic.I have been using these heavily for years and they hold up
    quite well. They are far less costly than through most of the major
    jewelry tool suppliers. I also have one with the replaceble faces
    that i like very much for certain jobs. 

Hope this helps. 
Dave Giulietti

 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________