[Jewelry making - Article 00986] - Re: [Orchid] Mallet making

[Chuck Hunner]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Dave,

    I used a big cylinder bur on my flex shaft tool to clean out the
    excess material. A large rattail file would work well too. Once I had
    the handle snuggly wedged into the head, I drilled a single hole into
    the head and handle. I put a wood screw into the hole and the hammer
    has worked like a champ ever since. 

    Asheville Chuck in Burlington, Ontario making another labyrinth 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________