[Jewelry making - Article 00512] - Re: [Orchid] Sandblasting set up

[Silverspotstudio]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Seem like in this day and age of common sense and technology,
>     someone would have noticed how much sense it makes to not have all
>     the dust flying toward the users face. Is it just that the
>     designers and engineers don't have to use them, so they don't
>     care?

    Maybe they were left-handed! I never realized what an advantage that
    was until the thread on polishing with the flex-shaft :) 

    Seriously, though: the reversible motor would work for buffs and
    abrasives, but wouldn't the direction of cut on all your burs have
    to be reversed for them to work properly with the flex-shaft
    spinning the other way? 

    You're right to wonder whose clever idea that was (even if it works
    out okay for me). 

Cheers,

Jessee Smith
Obligate Southpaw
www.silverspotstudio.com
Cincinnati, Ohio

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________