[Jewelry making - Article 00407] - Re: [Orchid] PMC firing time?

[Elaine Luther]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    You just pick one firing time. You do have a choice though. You don't
    say which version of PMC you're using. If it is PMC+ your choices
    are: 

    1470 for 30 minutes
    1650 for two hours

    and there's a lower temperature, but I don't remember it, because I
    never use it. 

    It's one or the other. 

    Check your clay package, there's a little piece of paper in there
    that lists your choices. 

Elaine
Elaine Luther
Metalsmith, Certified PMC Instructor
http://www.CreativeTextureTools.com (TM)
Hard to Find Tools for Metal Clay

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________