[Jewelry making - Article 00391] - Re: [Orchid] Tumbling for softer matte finish

[Judy Hoch]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Alan - You are on to something - only don't use steel for this. 

    First - oxidize your pieces.

    Second - Put them in a medium abrasive and run in a vibratory
    tumbler  for about 6 hours. 

    Third - Remove, set stones and sell. 

    Couldn't be easier, works every time. 

    If you only have a rotary tumbler, you can double the time, and
    check to  see when it's done.  Usually takes 2 to 3 times the vibe. 
    In either  case, be sure to use appropriate chemistry for the media. 

    I agree with the last post on tumblers - if you only can have one,
    get a good vibratory tumbler.  My tumbler is my favorite employee -
    no  vacations, sick leave or Monday morning brown bottle flu. 

Judy Hoch

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________