[Jewelry making - Article 00322] - [Orchid] Drilling ceramics

[Joseph Tanti]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Dear Orchidians,

    Its quite a while since I wrote last for a bench query. This time I
    want you to help me find a good drilling tip to make a small hole in
    a ceramic figure to place in it a small diamond. I would think a
    carbide drill tip would do but I would rather look for another
    opinion from you out there! 

Bye for now and thanks anyhow.
JOSEPH TANTI
http://jostanti.cjb.net

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________