[Jewelry making - Article 00269] - [Orchid] Lighter-weight hoses for Meco Midget torch?

[silvermason]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hi all.  

    As a result of the thread on this subject, I finally bought a Meco
    Midget and I like it very much. However, I sure wish it was as
    maneuverable as a Little Torch. Dragging those long heavy hoses
    makes it difficult to easily turn the torch 180 degrees for heating
    at different angles. Someone should invent some kind of swivel
    fitting to facilitate this. And apparently there are no
    lighter-weight hoses available. 

    Has anyone devised a fix for this problem? 

Thanks! 

Allan Mason
silvermason.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________