[Jewelry making - Article 00077] - [Orchid] Working with reticulated sheet

[Rawat Sani]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


Hi Folks,

    Question for ya: 

    I'm starting to work with some sterling sheet I reticulated a while
    back.  I want to set some cabochons in bezels on the sheet surface. 
    The solution I chose was to pierce the sheet, and file to fit a bezel
    cup I made and solder it in.  Pretty tedious, and high potential for
    error.  

    I can't really see an effective way to solder a bezel directly to
    the sheet, since it has an irregular surface.  

Any thoughts?
Rawat Sani

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________