[Jewelry making - Article 01640] - Re: [Orchid] Kiln - Paragon SC2 vs. PMC e360?

[jennifer friedman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Guy,

    Yes,  these kilns can be used for burnout of lost wax casting, but
    it would be better if you did not use the same kiln for burnout as
    you use for enameling.  It is okay to use with pmc burnout and lost
    wax, but not enamels due to contamination.  There are options for
    burning out the wax other than the specific oven.  You can heat even
    in your own home oven to melt the wax out.  Then move into the
    paragon, etc for heating moving toward casting. 

Jennifer Friedman
enamelist, jewelry artisan, ceremonial silver

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________