[Jewelry making - Article 00838] - [Orchid] aura22 and PMC+

[Jennifer Singh]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Ladies and Gentlemen! 

    I have  been playing with Aura22 for several weeks with limited
    success. The gold "paint" does not adhere securely to the PMC after
    firing. 

    I'm  using PMC+ and have tried applying the Aura 22 to both fired
    and un-fired clay. It sticks in some areas and not in others. 

    I am also attempting to use the Aura22 on a raised surface.not sure
    if that is part of the problem or not. 

    Here is a picture to reference:
    http://www.matissedesigns.com/Spring2005_goldangel 

    (I actually had to epoxy pieces of the gold that fell off!) 

Any suggestions?
Many thanks,
JJ

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________