[Jewelry making - Article 00647] - Re: [Orchid] PMC in general

[Jewelryartschool]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have to agree with everything that James has said. I'll add two
    more  reasons of my own... 

    The pieces made of PMC that I've seen to date have been far too
    heavy.  Casting can be heavy too if done incorrectly, but an
    experienced wax  modeler can make finished products as light as a
    fabrication. 

    Most important - to me at least - is that it can't be engraved! 
    <grin> 

Brian


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________