[Jewelry making - Article 00346] - Re: [Orchid] Platinum rivet

[Christine Pyman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Continue from:
http://www.ganoksin.com/orchid/archive/200502/msg01124.htm

>       has anyone had experience with making a rivet from platinum wire 

    thank you so much Peter for your very comprehensive answer to my
    question of a couple of weeks ago. The rivet is for decorative
    purposes only, so strength is not an issue, but it was the
    ductability of the metal that I had no info on, I was just worried
    about the melting point and the hardness in regards to the titanium.

thanks again, 
Christine in S Aust.


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________