[Jewelry making - Article 00054] - Re: [Orchid] CAD/CAM - 3Design vs ArtCam JewelSmith

[Taylor]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Myron, 

    I've replied in a little more detail to the email you sent me. 

    Though I thought I should post about an interesting PDF I found on
    the Gemvision site regarding questions to ask/consider when
    purchasing CAD software. 

    The link:
    http://www.gemvision.com/html/products/matrix/matrix_features.html
    There is also a PDF at the bottom of the page called: "CADCAM
    Purchasing Considerations.pdf" Pretty helpful, and if anyone from
    3Design are on this list they should take a look at how to influence
    a buyer, by arming them with quality information. ;-) 

Cheers, 
Taylor in Toronto

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________