[Jewelry making - Article 01129] - Re: [Orchid] Production cast in silver and pewter

[Kevin P. Kelly]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have a low relief carving that I would like to replicate on a small
    scale. That is from a low relief carving about 8" x 5" reduced to a
    carving about 15mm x 12mm. Is this possible?  I have no idea if this
    is in the realm of CAD. I have no knowledge of CAM. 

    Anyone out there in Orchid land who would like to take on this job?
    You may respond on line or off line as you please. 

Kevin Kelly

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________