[Jewelry making - Article 00930] - Re: [Orchid] Rolling mills suggestions

[Karen Christians]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Phil,

    Well ours is not Italian or German, but rather a Durston.  I have
    two, a small 150 mm flat and combination, and a 400 mm flat.  Both
    have withstood the test of students for nearly seven years, young and
    old.  They both have performed flawlessly. 

k

Karen Christians
M E T A L W E R X
50 Guinan St.
Waltham, MA  02451
Ph. 781/891-3854 Fax 3857
http://www.metalwerx.com/
Jewelry/Metalarts School & Cooperative Studio

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________