[Jewelry making - Article 00863] - Re: [Orchid] Flush setting into thin plate

[Steven Brixner]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I've seen diamonds set this way from behind.  A hole slightly
    smaller than the stone is drilled.  The diamond is put behind and
    held in with a small jump ring, soldered in place. 

Steve Brixner
Steven Brixner Jewelry - San Diego CA USA
mailto:mail AT brixnerdesign.com
http://www.brixnerdesign.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________