[Jewelry making - Article 00839] - Re: [Orchid] Grizzly flex shaft

[E. Luther]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>      The pedal comes without wires attached to it so you'll either have
>     to use the old wires or supply a new set of wires. 

    This is surprisingly easy.  I don't do electrical work, but even I
    can replace a plug.  They sell these plug repair kits at the
    hardware store and you just cut the wires, strip them a little, open
    the new plug, place the wires in and close. 

    Otherwise, the sewing machine repair guy would probably do it, or
    find a local junior college or trade school for electrical work and
    ask if they could do it for you. 

Elaine
Elaine Luther
Metalsmith, Certified PMC Instructor
http://www.CreativeTextureTools.com
Hard to Find Tools for Metal Clay

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________