[Jewelry making - Article 00519] - Re: [Orchid] Grizzly flex shaft

[Mike Zagielski]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Rebecca,

    I have not seen the Grizzly unit but most flex shaft machines utilize
    a standard "key" tip shaft. These can usually use other manufacturers
    handpices. The exceptions are Foredoms H Series and TXH Series shafts
    which have a square cross section tip. Dremel also has a square drive
    shaft but it has a much smaller cross section and can only use their
    handpiece. You can go to the foredom website http://www.foredom.com
    and verify your motor model to determine which handpiece you require.
    Or if you'd like you can call me at 800-441-0625 between 9 am to 4 pm
    eastern standard time and I'd be more than happy to answer your
    questions and provide maintenance tips. 

Mike Zagielski,
Foredom Sales Manager

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________