[Jewelry making - Article 00031] - Re: [Orchid] Techno X handpiece problems

[ringdoc]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    if I remeber right there is a screw at the bottom of the collet on
    that handpiece that adjusts the collet tension. these handpieces do
    wear qute a bit, as most( not all) jewelers try to open the collet
    with the burr still moving, wears em out real fast. last time we had
    one repaired it was between 50 and 90 bucks not counting shipping
    both ways. a few years back there was only a few poepe that worked on
    the techno X.  hoefully you will have better luck getting it serviced

ringdoc


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________