[Jewelry making - Article 01455] - Re: [Orchid] Techno X handpiece problems

[The Doctor]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Most quick-change handpieces are not user-serviceable. Also, most
    manufacturers advise keeping a bit in the collet at all times, even
    when not in use,  to prevent breakage and premature wear. Closing
    the collet lever once without a bit in place can cause immediate
    damage. I hope someone here knows how you can repair it, but I fear
    you may have to send it in for repair or replacement. 

James in SoFl

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________