[Jewelry making - Article 01398] - Re: [Orchid] Torch and other technical problems

[diamondeddy2]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    The problem is in the regulator. I have had this very same thing
    happen on the same torch setup. My local welding supply house said
    they could rebuild it to function properly, but the problem never
    was eliminated.  I work with mine an average of 4-5 hours a day/5
    days a week, and couldn't wait long enough for them to figure it
    out, so I ended up getting a new regulator to remedy the problem.
    Just a single day without is devastating to the work schedule. 

Ed in Kokomo  


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________