[Jewelry making - Article 01337] - Re: [Orchid] Satin cast xtreme

[kevdan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have had good luck with kerr satin cast I have been doing normal
    burn out scheduals and cast at 1000 degree flask temps but have had
    no succes using a vacume caster or an elctromelt. I use my platinum
    casting machine (verticle spin caster) and hydrogen and oxygen and
    get real good results I am sure you could use a traditional spin
    caster and propane and oxygen i just am using what I have. I have
    used the platinum investment but it is not necesary I have used both
    the quick vest and the slow stuff and notice no difference from
    regular investment. hope this helps 

Sincerely Kevin


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________