[Jewelry making - Article 01103] - Re: [Orchid] Vacuum casting seal problem

[Fr. George Aquaro]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Dear Friends,

    Thank you all for your input.  I discovered that all of my flasks,
    including the new ones, were (in some cases seriously) out-of-flat. 
    So, as I'm getting ready for another batch of casting, I am grinding
    them flush. 

    I am also planning to try the newspaper gasket method.  All the
    lines are rock solid.  I will also do a run-through before they go
    into the oven. 

    My gratitude to you all, especially Hanuman, for making such a
    brilliant site!

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________